Brightwell NeoMarine Sea Salt 150 Gallon Bucket

• 150g bucket
• Advanced salt mix for all marine and reef aquariums

NēoMarine Salt Mix
This formula has undergone extensive testing and has produced very impressive results. Livestock from every common family of ornamental marine organisms has been maintained in water prepared with this formula without incident, many of them reproducing freely when they had not done so in aquaria maintained with other salt brands.

Instructions and Guidelines
Each 138.8 grams of NēoMarine will increase the specific gravity of 1 US-gallon of purified water to approximately 1.024 g/cm3. To obtain a higher or lower specific gravity when preparing water, divide the desired value by 1.024 and then multiply this number by the volume of water (in gallons) being prepared, then multiply this value by 138.8 to obtain the mass of salt required (in grams) to be added (example: if target SG is 1.021 in 5.0 gallons of water: 1.021 ÷ 1.024 = 0.998; 0.998 × 5.0 = 4.985; 4.985 × 138.8 g = 691.92 g, as opposed to 694.0 g required to increase SG in 5.0 gallons to 1.024 g/cm3). If not using an accurate scale to measure salt, dissolve approximately 4 oz., or half a cup, of salt mix in each gallon of purified water to obtain a target specific gravity between 1.021 – 1.024 g/cm3, and adjust as needed by adding more salt or water to increase/decrease specific gravity, respectively.

It is strongly recommended that water purified via reverse osmosis and/or deionization be used for seawater preparation. Add the required amount of water and salt to a clean container such as a large plastic pail and mix it thoroughly with a submersible pump. Always use an accurate hydrometer or (preferably) refractometer to determine the specific gravity of prepared seawater. Ensure that the water temperature matches that of the established aquarium (use a submersible heater if necessary). 

Although the prepared water may be used immediately upon reaching the desired specific gravity and pH (and temperature), it is recommended that at least one hour (and preferably several hours) of mixing be allowed to pass before adding the water to an established aquarium; this extra time enables gas formed during the salt dissolution to escape, further stabilizing pH.

Water changes in all marine aquaria should be made weekly to help maintain the natural seawater ionic ratios.